Sony VPL-CX70
15
Projecting
Pr
oj
oj
ec
tin
tin
g
t
h
e
P
ict
ur
e
To connect to a video GBR/
Component output connector
Component output connector
A SMF-402 Signal Cable (not supplied)
HD D-sub 15-pin (male)
↔ 3 × phono jack
B Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
• Set the aspect ratio using “Wide Mode” on
the INPUT SETTING menu according to the
input signal.
input signal.
• When you connect the projector to a video
GBR output connector, select “Video GBR”
or when you connect the projector to a
component output connector, select
“Component” with the “Input-A Signal Sel.”
setting on the SET SETTING menu.
or when you connect the projector to a
component output connector, select
“Component” with the “Input-A Signal Sel.”
setting on the SET SETTING menu.
• Use the composite sync signal when you
input the external sync signal from video
GBR/component equipment.
GBR/component equipment.
Projecting
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
red and the projector goes into standby
mode.
2
Press the ?/1 key.
The ON/STANDBY indicator flashes in
green and the Advanced Intelligent
Auto-setup starts. The lens protector
opens, the powered tilt adjuster rises and
stops at the previously adjusted position
and adjusts the focus.
green and the Advanced Intelligent
Auto-setup starts. The lens protector
opens, the powered tilt adjuster rises and
stops at the previously adjusted position
and adjusts the focus.
Notes
Left side
to
audio
output
(R)
audio
output
(R)
VCR
to video
GBR/
component
output
GBR/
component
output
to
audio
output
(L)
ON/STANDBY indicator
Rear remote
control detector