Sony VPL-VW60 User Manual
54
D:\job\3218492111\3218492111VPLVW60UC\010GB_VPLVW60UC\0
8OTH.fm
8OTH.fm
masterpage:Left
VPL-VW60
3-218-492-11 (1)
Troubleshooting
If the projector appears to be operating erratically, try to diagnose and correct the problem
using the following instructions. If the problem persists, consult with qualified Sony
personnel.
using the following instructions. If the problem persists, consult with qualified Sony
personnel.
Power
Picture
Symptom
Cause and Remedy
The power is not turned on.
c After about one minute, turn the power on.
c Close the lamp cover securely, then tighten the screws securely.
c Close the lamp cover securely, then tighten the screws securely.
(
1 page 58)
c Close the filter holder securely. (1 page 60)
c Check warning indicators. (1 page 56)
c Check warning indicators. (1 page 56)
Symptom
Cause and Remedy
No picture.
c Check that the proper connections have been made.
(
1 page 17)
c Select the input source correctly using the INPUT button.
(
1 page 27)
c Set the computer signal to output from an external monitor.
c Set the computer signal to output only to an external monitor.
c Select “Computer,” “Component” or “Video GBR” for “Input-A
c Set the computer signal to output only to an external monitor.
c Select “Computer,” “Component” or “Video GBR” for “Input-A
Signal Sel.” on the Setup
menu according to the input
signal. (
1 page 47)
The picture from the
INPUT A connector is
colored strange.
INPUT A connector is
colored strange.
c Select “Computer,” “Component” or “Video GBR” for “Input-A
Signal Sel.” on the Setup
menu according to the input
signal. (
1 page 47)
The picture from the
VIDEO INPUT or
S VIDEO INPUT
connector is colored
strange.
VIDEO INPUT or
S VIDEO INPUT
connector is colored
strange.
c Adjust the picture of the Picture
menu. (
1 page 40)
c Set “Color System” in the Setup
menu to match the color
system being input. (
1 page 47)
The color gradation of the
dark area or the bright area
of the picture from the
HDMI 1 or HDMI 2
connector becomes
unclear.
dark area or the bright area
of the picture from the
HDMI 1 or HDMI 2
connector becomes
unclear.
c The color gradation of the dark area or the bright area may
become unclear when a signal other than those from HDMI
standard is input. Adjust the “Brightness” and the “Contrast” in
the Picture
standard is input. Adjust the “Brightness” and the “Contrast” in
the Picture
menu. (
1 page 41)
The picture is too dark.
c Adjust the “Contrast” or “Brightness” of the Picture
menu
properly. (
1 page 41)
The picture is not clear.
c Adjust the focus. (1 page 24)
c Condensation has accumulated on the lens. Leave the projector
c Condensation has accumulated on the lens. Leave the projector
for about two hours with the power on.
00COV.book Page 54 Thursday, June 21, 2007 1:05 PM