Sony VPL-CS6

Page of 164
GB 
18
Connecting the Projector
Connecting the Projector
When you connect the projector, make sure to:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose connections may increase noise and 
reduce performance of picture signals. When pulling out a cable, be sure to 
pull it out from the plug, not the cable itself
To connect the projector, refer to the illustrations on the next and the 
following pages.
This section describes how to connect the projector to a computer.
For more information, refer to the computer’s instruction manual.
• The projector accepts VGA, SVGA, XGA, SXGA (VPL-CX6/EX1 only) and 
SXGA+ (VPL-CX6/EX1 only) signals. However, we recommend that you set the 
output mode of your computer to XGA mode (VPL-CX6/EX1) or SVGA mode 
(VPL-CS6) for the external monitor.
• If you set your computer, such as a notebook type, to output the signal to both your 
computer’s display and the external monitor, the picture of the external monitor may 
not appear properly. Set your computer to output the signal to only the external 
monitor.
For details, refer to the computer’s operating instructions supplied with your 
computer.
• This projector is compatible with a DDC2B (Digital Data Channel 2B). If your 
computer is compatible with a DDC, turn the projector on according to the following 
procedures.
1
Connect the projector to the computer by using the supplied HD D-sub 15 pin cable.
2
Turn the projector on.
3
Start the computer.
Connecting with a Computer
Notes