Sony VPL-FX40 User Manual

Page of 58
46
Troubleshooting
Warning Messages
Use the list below to check the meaning of the messages displayed on the screen.
Caution Messages
Use the list below to check the meaning of the messages displayed on the screen.
Messages List
Message
Meaning and Remedy
High temp.! Lamp off in 1 
min.
The internal temperature is too high.
c Turn off the power.
c Check to see that nothing is blocking the ventilation holes.
Frequency is out of range!
• This input signal cannot be projected as the frequency is out of the 
acceptable range of the projector.
• The resolution setting of the output signal of the computer is too 
high.
c Input a signal that is within the range of the frequency.
Please check Input-C 
Signal Sel.
You have input an RGB signal from the computer when “Input-C 
Signal Sel.” in the Setup menu is set to “Component.”
c Set “Input-C Signal Sel.” correctly (see page 33).
Please replace the Lamp 
and clean the Filter.
• It is time to replace the lamp and clean the air filter.
c Replace the lamp  (see page 40) and clean the filter (see 
• If this message appears again after you replace the lamp, the lamp 
replacement process is not complete.
c Perform the operations in step 8 to 11 on page 41.
To erase a message, press any key on the control panel of the 
projector or on the remote commander.
The projector temperature 
is high. “Cooling Setting” 
should be “High” if the 
projector is being used at 
high altitude.
c Check to ensure that the ventilation holes on the projector are not 
covered (see page 11).
c When using the projector at high altitude, set the “Cooling 
Setting” to “High”. 
If the temperature inside the projector remains high, the “Cooling 
Setting” is switched to “High” in one minute, then the fan speed 
increases.
Message
Meaning and Remedy
Not applicable!
You have pressed the wrong key.
c Press the appropriate key.
The panel keys are locked!
“Panel Key Lock” in the Function menu is set to “On.”
c All the keys on the control panel of the projector are locked. 
Operate the projector with the keys on the Remote Commander 
(see page 35).
Note
Note