Sony VPL-CS20 User Manual
11
Projecting
Pr
oj
oj
ec
tin
tin
g
t
h
e
P
ict
ur
e
To connect to a video GBR/
Component output connector
Component output connector
A SMF-402 Signal Cable (not supplied)
HD D-sub 15-pin (male)
↔ 3 × phono jack
B A/V connecting adaptor (supplied)
C
C
Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
Set the aspect ratio using “Wide Mode” on the
Signal menu according to the input signal.
Signal menu according to the input signal.
Projecting
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
red and the projector goes into standby
mode.
2
Press the ?/1 key.
The ON/STANDBY indicator flashes in
green and the Advanced Intelligent
Auto-setup starts. The powered tilt
adjuster rises and stops at the previously
adjusted position and adjusts the focus.
green and the Advanced Intelligent
Auto-setup starts. The powered tilt
adjuster rises and stops at the previously
adjusted position and adjusts the focus.
Note
Left side
Red
to
audio
output
(R)
to
audio
output
(R)
VCR
to video
GBR/
component
output
White
to
audio
output
(L)
ON/STANDBY indicator
Rear remote control
detector
detector