Sony VPL-PS10 User Manual

27

 (GB)

Using the Menu

The projector is equipped with an on-screen menu for
making various adjustments and settings.

(VPL-PX15/PX10 only)
Before operation, confirm that the PJ/NETWORK
select switch on the Remote Commander is set to PJ.
If it is set to NETWORK, the menu display will not
appear even when you press the MENU key on the
Remote Commander.

Press the MENU key.
The menu display appears.
The menu presently selected is shown as a yellow
button.

PICTURE CTRL

CONTRAST:

80

BRIGHT:

50

RGB ENHANCER: 30

GAMMA MODE: GRAPHICS

COLOR TEMP: LOW

VOLUME:

50

INPUT-A

Use the 

M or m key to select a menu, then press

the 

, or ENTER key.

The selected menu appears.

SET SETTING

STATUS:

ON

INPUT-A:

COMPUTER

AUTO INPUT SEL: OFF

      LANGUAGE: ENGLISH

POWER SAVING: OFF

IR RECEIVER:

FRONT&REAR

INPUT-A

Select an item.
Use the 

M or m key to select the item, then press

the 

, or ENTER key.

Make settings or adjustments on an item.

Press the MENU key.
The menu display disappears automatically if no key
is pressed for one minute.

Press the RESET key.
“Complete!” appears on the screen and the settings
appearing on the screen will be reset to their factory
preset values.
Items that can be reset are:
• “CONTRAST, ” “BRIGHT, ” “COLOR, ” “HUE,”

“SHARP,” and “RGB ENHANCER” in the
PICTURE CTRL menu.

• “DOT PHASE, ” “SIZE H,” and “SHIFT” in the

INPUT SETTING menu.

• “DIGIT KEYSTONE” in the INSTALL SETTING

menu.

The settings are automatically stored in the projector
memory.

When there is no input signal, “NO INPUT–Cannot
adjust this item.” appears on the screen, and the items
mentioned above cannot be adjusted.

You can set the display position of the menu, the
intensity of the background picture, and the color of
the menu items as you like.

Menus           Setting items