Sony WM-EX122 User Manual

To wind the tape

Press 

0 or ).

To adjust the volume

Turn the VOLUME
control.

To stop

Press 

p STOP.

• Do not use cassettes longer than 90 minutes except for long

continuous playback.

• If the tape is playing but no sound comes out, the batteries may be

weak. Replace all batteries with new ones.

• If your Walkman has not been used for a long time, run the

Walkman for a few minutes before inserting a cassette.

• Do not open the cassette holder while the tape is running.
• Do not wind the headphones cord around the Walkman. The

buttons may be kept pressed, causing unnecessary battery usage.

Set the MEGA BASS switch to ON to produce deep and
powerful sound.

If the AVLS switch is set to LIMIT, the MEGA BASS effect is reduced.

3-810-695-13(1)

Printed in Malaysia

Sony Corporation © 1996

WALKMAN is a registered trademark of Sony Corporation.

The model number is located at the rear and the
serial number is located inside the cassette holder.
Record the serial number in the space provided
below. Refer to them whenever you call upon your
Sony dealer regarding this product.

Model No. WM-EX122

Serial No.

Insert two AA (R6) batteries in correct polarity.

• When you are not going to use your Walkman for a long time,

remove the batteries to prevent damage from battery leakage and
corrosion.

• When the batteries become weak, the sound will be unstable or can

not be heard. In such a case, replace both batteries.

• Concerning the battery life, see “Specifications”.

You can connect the following external power sources
through the DC IN 3 V jack located on the bottom.
(When you plug a cord into the DC IN 3 V jack, the
internal batteries are automatically bypassed.)
•House current using an AC-E30HG AC power adaptor

Use only the recommended
AC-E30HG AC power adaptor (not
supplied). Do not use any other AC
power adaptor.

9 PLAY.

NORM

CrO

2

 / 

METAL

PLAY

2

pSTOP

0 )

9PLAY

ON

OFF