Sony XC-EU50 User Manual
6
Overview
Rear Panel
Note
When you do switch settings, make sure the unit is off.
1
VIDEO OUT/DC IN/SYNC (video output/DC
power input/sync signal I/O) connector (12-pin)
Connect a CCXC-12P05N camera cable to this
connector for the +12V DC power supply and the
video signal output from the camera module. When a
sync signal generator is connected to this connector,
the camera module is synchronized with the external
sync signals (HD/VD signals).
Connect a CCXC-12P05N camera cable to this
connector for the +12V DC power supply and the
video signal output from the camera module. When a
sync signal generator is connected to this connector,
the camera module is synchronized with the external
sync signals (HD/VD signals).
2
Shutter speed/Mode setting DIP switch
Shutter speed (bits 1–4):
Set an appropriate shutter speed. (Factory setting:
OFF)
OFF)
Potential accumulation mode (bit 5):
(Factory setting: FRAME)
Restart reset/External trigger shutter mode switch
(bits 6–8):
(Factory setting: Normal)
(Factory setting: Normal)
γ compensation ON/OFF switch (bit 9):
Turn on this switch to enable the
γ compensation.
(Factory setting: OFF)
GAIN switch (bit 0):
This switch selects MGC (manual adjustment) or
AGC (automatic adjustment). (Factory setting:
MGC)
AGC (automatic adjustment). (Factory setting:
MGC)
1
VIDEO OUT/DC IN/SYNC (video output/DC power
input/sync signal I/O) connector (12-pin)
input/sync signal I/O) connector (12-pin)
2
Shutter speed/Mode setting DIP switch
3
Manual GAIN (M GAIN) control knob
4
HD/VD signal input/output switch
5
75
Ω termination switch
3
Manual GAIN (M GAIN) control knob
If you have selected MGC with the GAIN switch (DIP
switch 2), this knob adjusts the gain. (Factory setting:
twelve o’clock position)
switch 2), this knob adjusts the gain. (Factory setting:
twelve o’clock position)
Note
If you have selected FRAME using the Potential
accumulation mode (DIP switch 2), set this knob to
MAX. (This is due to requirement CCD.)
accumulation mode (DIP switch 2), set this knob to
MAX. (This is due to requirement CCD.)
4
HD/VD signal input/output switch
Set the switch to INT to output HD/VD signals from
the camera module.
Set the switch to EXT to input HD/VD signals from an
external unit. (Factory setting: EXT)
the camera module.
Set the switch to EXT to input HD/VD signals from an
external unit. (Factory setting: EXT)
5
75
Ω termination switch
Turn this to OFF when not terminated. (Factory
setting: ON)
setting: ON)