Sony XR-3753 User Manual
16
EN
Disc play (XR-C353 only)
Problem
Playback sound skips.
Cause/Solution
A dusty or defective disc.
Troubleshooting guide
The following checklist will assist in the correction of most problems you may encounter with your
unit.
Before going through the checklist below, refer to the operating procedures.
unit.
Before going through the checklist below, refer to the operating procedures.
General
Cause/Solution
•
Adjust the volume with (+).
•
Set the fader control to the center position for 2-speaker
systems.
systems.
Remove the front panel and clean the connectors. See “Cleaning
the Connectors” in “Maintenance” for details.
•
An optional power amplifier is connected and you are not
using the built-in amplifier (XR-C353 only).
using the built-in amplifier (XR-C353 only).
•
The beep tone is muted.
Problem
No sound.
Indications do not appear on
the display.
the display.
No beep tone.
Tape playback
Cause/Solution
Contamination of the tape head. n Clean the head.
•
There is noise in the space between tracks.
•
A blank space is too short (less than four seconds).
•
+ on (SEEK/AMS) is pressed immediately before the
following track.
following track.
•
= on (SEEK/AMS) is pressed immediately after the track
starts.
starts.
•
A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
sound level is treated as a blank space.
Problem
Playback sound is distorted.
The AMS does not operate
correctly.
correctly.
Radio reception
Problem
Preset tuning is not possible.
Automatic tuning is not possible.
Cause/Solution
•
Store the correct frequency.
•
The broadcast is too weak.
The broadcast is too weak. n Use manual tuning.