Sony XR-M500R User Manual
40
Troubleshooting guide
The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connections and operating procedures.
Before going through the checklist below, check the connections and operating procedures.
General
Radio reception
Problem
Preset tuning is not possible.
Automatic tuning is not
possible.
possible.
The stations cannot be
received.
The sound is hampered by
noises.
received.
The sound is hampered by
noises.
The “ST” indication flashes.
Cause/Solution
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
• The broadcast signal is too weak.
•The broadcast signal is too weak.
t Use manual tuning.
•The local seek mode is set to “on.”
t Set the local seek mode to “off” (page 14).
Connect a power aerial control lead (blue) or accessory power
supply lead (red) to the power supply lead of a car’s aerial
booster. (When your car has built-in FM/MW/LW aerial in the
rear/side glass only.)
supply lead (red) to the power supply lead of a car’s aerial
booster. (When your car has built-in FM/MW/LW aerial in the
rear/side glass only.)
•Tune in the frequency accurately.
•The broadcast signal is too weak.
•The broadcast signal is too weak.
t Set to Mono mode (page 14).
Problem
No sound.
The contents of the memory
have been erased.
have been erased.
The sound is noisy.
Cause/Solution
•Cancel the ATT function.
•Set the fader control to the centre position for two-speaker
•Set the fader control to the centre position for two-speaker
systems.
•Press (+) of the VOL buttons to adjust the volume.
• The power cord or battery has been disconnected.
• The reset button was pressed.
• The reset button was pressed.
t Store again into the memory.
You are using a mobile phone.
Tape playback
Problem
The sound is distorted.
The AMS does not operate
correctly.
correctly.
Cause/Solution
The tape head is contaminated.
t Clean the head with a commercially available dry-type
t Clean the head with a commercially available dry-type
cleaning cassette.
•
There is noise in the space between tracks.
•
A blank space is too short (less than four seconds).
•
A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
sound level is treated as a blank space.