Denon avr-1804 884 ost-790 Service Manual

Page of 3
 
100 Corporate Drive Mahwah, NJ 07430
 
 
       
 
 
 
Service Bulletin
 
No. : OST-790 
Date:
 May 10, 2007 
_____________________________________________________________
 
 
Model:
 
AVR-1804, 
AVR-884       
 
 
Subject: 
Countermeasure for play in the Rotary Encoder Shaft.
 
 
 
 
 
 
 
 
 
 
Symptom:
 There customer complains of “play” or looseness in the Master 
Volume shaft. 
 
 
Solution:  
An updated rotary Encoder is available.
 
• The improved rotary encoder included the following two items for reducing the 
play between the Shaft and the bearing:  
1) The width of the bearing section is changed to 7mm from 4mm to increase 
bearing area of the Rotary Encoder.  
2) A frame emboss was added to shorten the gap between the shaft and the 
frame. (Convex 0.1 mm) 
 
• Modification Procedure:  
1) Remove 9 screws on the side and rear of the Top Cover, and remove the Top 
Cover. (Refer to the Fig. 1.)  
2) Remove the 8 screws that are fixing Front Panel to Chassis, remove 5 
Connectors, and remove the Front Panel Assembly from the unit. (Fig. 2)  
3) Remove the MASTER VOLUME Knob and SELECT Knob.  Remove 15 
screws and two nuts that are fixing the Display P. W. Board.  
4) Replace the Rotary Encoders. (Refer to the Service Manual VEC301, 302.) 
______________________________________________________________________________________ 
CONFIDENTIALITY NOTICE: 
The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their 
employees.  This document may contain information that is privileged, confidential and may be protected from disclosure under 
applicable laws and terms of the DENON Service Agreement.  Any distribution, disclosure, dissemination or copying of this 
document and the information it contains is prohibited.  No responsibility will be accepted by DENON for any damage, injury or loss 
resulting from the misuse of the information contained in this document.