Denon avr-4310ci avr-4810 dz10-029 Service Manual

Page of 2
 
100 Corporate Drive Mahwah, NJ 07430
 
 
       
 
 
 
Service Bulletin
 
No. : 
 DZ10-029 
Date:
 
May 24, 2010 
_____________________________________________________________
 
 
Model:
 
AVR-4310CI, 
AVR-4810CI 
     
 
 
Subject: 
Reinforcement of the pattern of "8U-110063-2 AMP CONNECT 
UNIT".
 
Countermeasure is applicable only upon claim from the customer.   
 
 
 
 
 
 
 
Symptom:
 No power. A pattern on 8U-110063-2 AMP CONNECT UNIT might 
open. 
Cause:  1) The customer might apply the minus terminal of Loudspeakers to 
chassis of unit.  
2) The width of the pattern was too narrow and current handling capacity is 
insufficient. 
 
Solution:  
The position of soldering the wire on the "8U-110063-2 AMP 
CONNECT UNIT" is changed, see the following for details. 
 
MODIFICATION: 1) Replace any damaged components on "8U-110063-1 
SPEAKER P.W.B. UNIT ASSY" with a new part.  
2) Remove the black wire which is soldered on the pattern side of CW231 on 
"8U-110063-2 AMP CONNECT UNIT", and then solder the wire to the new 
position (Pin #17 and 19 of CW231) on the same P.W.B. (Refer the following 
picture for details) 
 
 
 
______________________________________________________________________________________ 
CONFIDENTIALITY NOTICE: 
The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their 
employees.  This document may contain information that is privileged, confidential and may be protected from disclosure under 
applicable laws and terms of the DENON Service Agreement.  Any distribution, disclosure, dissemination or copying of this 
document and the information it contains is prohibited.  No responsibility will be accepted by DENON for any damage, injury or loss 
resulting from the misuse of the information contained in this document.