Denon DVD2500BTCi User Manual

Page of 40
II
ESPAÑOL
FRANÇAIS
ENGLISH
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme 
NMB-003 du Canada.
FCC INFORMATION (For US customers)
1. PRODUCT
This product complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions: (1) this product may not cause harmful 
interference, and (2) this product must accept any interference received, 
including interference that may cause undesired operation.
2. IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT
This product, when installed as indicated in the instructions contained in 
this manual, meets FCC requirements. Modification not expressly 
approved by DENON may void your authority, granted by the FCC, to use 
the product.
3. NOTE
This product has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful 
interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, 
if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If 
this product does cause harmful interference to radio or television 
reception, which can be determined by turning the product OFF and ON, 
the user is encouraged to try to correct the interference by one or more 
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the product into an outlet on a circuit different from that 
to which the receiver is connected.
• Consult the local retailer authorized to distribute this type of 
product or an experienced radio/TV technician for help.
CAUTION:TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG 
TO WIDE SLOT, FULLY INSERT.
ATTENTION:
POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME 
LA PLUS LARGE DE LAFICHE DANS LA BORNE 
CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.
䡵 Note on use / Observations relatives a l’utilisation / Notas sobre el uso
Allow for sufficient heat dispersion when installed
in a rack.
• Eviter des températures élevées 
Avoid high temperatures.
Tenir compte d’une dispersion de chaleur suffisante 
lors de l’installation sur une étagère.
• Evite altas temperaturas
Permite la suficiente dispersión del calor cuando
está instalado en la consola.
• Handle the power cord carefully.
Hold the plug when unplugging the cord.
• Manipuler le cordon d’alimentation avec précaution.
• Keep the apparatus free from moisture, water, and
dust.
lapoussière.
• Mantenga el equipo libre de humedad, agua y
polvo.
• Unplug the power cord when not using the
apparatus for long periods of time.
• Débrancher le cordon d’alimentation lorsque
l’appareil n’est pas utilisé pendant de longues
périodes.
• Desconecte el cordón de energía cuando no utilice
el equipo por mucho tiempo.
* (For apparatuses with ventilation holes)
• Do not obstruct the ventilation holes.
• Ne pas obstruer les trous d’aération.
• No obstruya los orificios de ventilación.
• Do not let foreign objects into the apparatus.
• Ne pas laisser des objets étrangers dans l’appareil.
• No deje objetos extraños dentro del equipo.
• Do not let insecticides, benzene, and thinner come
in contact with the apparatus.
• Ne pas mettre en contact des insecticides, du
benzène et un diluant avec l’appareil.
• No permita el contacto de insecticidas, gasolina y
diluyentes con el equipo.
• Never disassemble or modify the apparatus in any
way.
• Ne jamais démonter ou modifier l’appareil d’une
manière ou d’une autre.
• Nunca desarme o modifique el equipo de ninguna
manera.
Tenir la prise lors du débranchement du cordon.
• Maneje el cordón de energía con cuidado.
Sostenga el enchufe cuando desconecte el cordón
de energía.
• Protéger l’appareil contre l’humidité, l’eau et
E5E01UD_EN.book  Page II  Wednesday, November 28, 2007  2:16 PM