Denon fwcv v0073 manual avr-2310 avc2310 Service Manual
The Operating Manual for DENON AV receiver/amplifier firmware update.
Page 7 / 7
3. Specific update mode.
If you failed update during Main CPU update, then you need to use this specific update procedure.
1) The AV receiver/amplifier is connected with PC with the RS-232C cable. Refer to 1.3.
2) Push the [Surround MODE < ] + [MENU] button simultaneously.
And turn on the power switch of the AV receiver/amplifier.
3) Power indicator indicates red color. This is specific update mode.
4) Please execute the firmware update. Refer to 2.3.
4. Confirming the firmware’s number after upgraded
After completion of the updating operation, the new version number can be confirmed by starting up
the AVR-2310 or AVC-2310 according to the following procedure.
With the following operation, the AVR-2310 or AVC-2310 can be set to the Flash-ROM
Version-Number Confirmation Mode.
Turn the power of the AVR-2310 or AVC-2310 on, while holding both [DIMMER] button and
[STATUS] button on the front panel simultaneously.
Every time the [STATUS] Button is pressed, version numbers of the S/N, Main, Sub,
etc. are indicated on the front panel section in the following order.
Depression Button
Name
Remarks
-
AVR2310 XX
or AVC2310 XX
or AVC2310 XX
1 STATUS
S/N. xxxxxxxxxx
Main Ver00.64
Main Ver00.64
2 STATUS
Sub Ver00.24
3 STATUS
DSP Ver50.14
4 STATUS
Audio PLD
Ver00.47
5 STATUS
OSD Config
6 STATUS
200905080009
OSD PRG
OSD PRG
7 STATUS
200905290030
OSD DAT
OSD DAT
8 STATUS
200905290011
DIMMER
STATUS
Turn
Power ON
+
+