Nokia 7110 Service Manual
PAMS
Technical Documentation
NSE–5
Service Software Instructions
Page 5
Issue 1 07/99
Service Software
To run the After Sales SW, a parallel port software protection device
(PKD–1) has to be connected. TDF–4 box must connected to PC for
flashing purposes. The user can use PC–locals functions in modules for
testing NSE–5 mobile stations (MS).The test functions send test
messages from PC to MS and receive results and show them in the PC
display. The messages can be sent via M2BUS or FBUS.
(PKD–1) has to be connected. TDF–4 box must connected to PC for
flashing purposes. The user can use PC–locals functions in modules for
testing NSE–5 mobile stations (MS).The test functions send test
messages from PC to MS and receive results and show them in the PC
display. The messages can be sent via M2BUS or FBUS.
Note1: if this software is to be run on laptops, the power saving feature MUST be
switched off. if this is not switched off you need to re–establish connection to the phone
after power saving has been active.
switched off. if this is not switched off you need to re–establish connection to the phone
after power saving has been active.
Hardware requirements for Windows 3.1x
The recommended minimum hardware standard to run Service Software
is any computer which is 386 33 MHz or greater with at least 4 MB of
memory and VGA type display (640 x 480). This assumes that only the
WinTesla with After Sales Support Modules is active, i.e. other Windows
packages are not running in the background.
is any computer which is 386 33 MHz or greater with at least 4 MB of
memory and VGA type display (640 x 480). This assumes that only the
WinTesla with After Sales Support Modules is active, i.e. other Windows
packages are not running in the background.
Hardware requirements for Windows 95
The recommended minimum hardware standard to run Service Software
is any computer which has Pentium processor, memory 8 MB and meets
HW requirements recommended by Microsoft.
is any computer which has Pentium processor, memory 8 MB and meets
HW requirements recommended by Microsoft.
Software Environment of the Support Modules
The Service Software user interface is intended for the following
environments: Microsoft Windows 3.1x and Windows 95 environment
running in enhanced mode as well as Microsoft NT. Detailed information
about Windows and application usage can be found from the Microsoft
Windows Version 3.1 Users Guide chapter one (Windows Basics) and
chapter two (Application Basics).
environments: Microsoft Windows 3.1x and Windows 95 environment
running in enhanced mode as well as Microsoft NT. Detailed information
about Windows and application usage can be found from the Microsoft
Windows Version 3.1 Users Guide chapter one (Windows Basics) and
chapter two (Application Basics).
As an ordinary Windows application, the main idea in the user interface is
that selections are made with menus, push buttons and shortcut keys.
Selections can be done by using keyboard and/or mouse. There is always
a status bar displayed at the bottom of the main window which contains
information about current actions.
that selections are made with menus, push buttons and shortcut keys.
Selections can be done by using keyboard and/or mouse. There is always
a status bar displayed at the bottom of the main window which contains
information about current actions.