Nokia 7270 Service Manual

RM-8/RM-47/RM-48

Nokia Customer Care

COMPANY CONFIDENTIAL

Issue 2 03/2005

The Phoenix window should now look like this:

Now the measurement setup, which has been built according to the chapter 8.1, should detect
the following output signal of the phone.

out

= +23dBm @ 836.6 MHz

If this is not the case, then go to the next chapter 8.3.2.1 GMSK for the troubleshooting.

Start the preparations as described in chapter 8.1.

EDGE:

First, select operation mode to the local. Then, select

→ Testing → RF control.

In the popup window these values are common:

• Active unit

→ TX

• Band

→ 850

• Operation mode

→ Burst

• RX/TX Channel

→ 190

In the popup window TX control values:

• EDGE

→ ON

• Tx data type

→ Alternate

• TX PA mode

→ High

• TX Power level

→ 10