Panasonic AJ-RC5 User Manual

When the VTR/SCENE enable switch has been set to SCENE, the S1 button, S2 button, S3
button, S4 button, SAVE button and LOAD button can be used to store the data that has been
adjusted by the unit in the unit’s memory as scene files.

Example: Saving data into scene No.1

1 Press the S1 button.

The selected scene No. button now blinks.

≥

To change to another scene No., simply press
the button that corresponds to that scene No.

≥

To release the scene No. selection, press the
scene No. button which is now blinking again.

1 Press the SAVE button within 10 seconds

of performing the operation in 1-1.

Both the selected scene No. button and SAVE
button start blinking.

2 Again press the SAVE button within 10

seconds of performing the operation in 2-
1.

While the data is being saved, both the selected
scene No. button and SAVE button stop
blinking and come on.

The save operation is completed when the
SAVE button goes off, the scene No. button
used to save the data stays on and the LOAD
button comes on.

After the data has been written in the memory,
the operation mode (scene mode) prescribed
by the saved scene data is established, and the
KNEE SLOPE, KNEE POINT, DETAIL,
GAMMA and M.PED VR control operations
differ slightly from their regular operations.  For
further details, refer to the section entitled
“Operation mode established by scene file data
<scene mode>.”