Panasonic AJ-PCD20P User Manual

E-10

Turn OFF the personal computer’s power.

Undo the six screws and remove the cover.

Mount the P2 drive in a 5-inch bay on the
personal computer. Use the screws supplied
with the P2 drive for mounting.
Please refer to your computer’s
instruction manual for guidance in
mounting to 5-inch bay drives.

<Notes>
z The P2 drive may not be able to be

fastened securely in some types of
personal computers.

z If all 5-inch bays are occupied, you will

need to remove one of the built-in drives to
make room for the P2 drive.

z The P2 drive should be used in a personal

computer whose design allows the front
panel of the Drive to be manipulated.

Plug a USB 2.0 cable B connector into the
USB connector on the P2 drive. then plug the
other end of the USB 2.0 cable into the USB
2.0 port on the personal computer.

<Note>
USB 2.0 connector pinouts vary according to
the type of motherboard type. Check your
computerís instruction manual before
purchasing a commercially available USB
2.0 cable (shielded).

Connect the P2 drive to the internal power
cable (4 pins) of the personal computer.

USB 2.0

DC IN 16V

DC IN 12V

IEEE 1394b

USB 2.0

DC IN 16V

DC IN 12V

IEEE 1394b

USB 2.0

DC IN 16V

DC IN 12V

IEEE 1394b

P_AJ-PCD20.book  10 ページ  ２００６年６月２８日　水曜日　午前９時４９分