Panasonic BT-LH2600W User Manual
31
REMOTE Specifications
(continued)
g Assignment of item priority levels
• When both “MARKER1” and “MARKER2” are ON at the same time, “MARKER1” has priority. However, when the
display aspect is 4:3, the “MARKER1” aspect is 16:9, and the “MARKER2” aspect is 4:3, “MARKER2” is
displayed. In this case, the “MARKER2” background is controlled.
displayed. In this case, the “MARKER2” background is controlled.
• When “MARKER BACK HALF” and “MARKER BACK BLACK” are simultaneously activated, priority goes to
“MARKER BACK BLACK”.
• When two or more of the following items - “INPUT SEL. VIDEO”, “INPUT SEL. Y/C”, “INPUT SEL SDI1”, “INPUT
SEL. SDI2” and “INPUT SEL. YP
B
P
R
/RGB” - are simultaneously activated, priority goes to the last item activated.
• When “GAMMA SEL. FILM” and “GAMMA SEL. STDIO/PST” are simultaneously activated, priority goes to
“GAMMA SEL. FILM”.
Refer to the following diagram and lower right table for the RS-232C terminal pin arrangement and connections.
Please contact the vendor for information about detailed systems which used the RS-232C.
Please contact the vendor for information about detailed systems which used the RS-232C.
g Connectors and signal names
Connector: D-SUB 9-pin (female)
Signal name
Signal name
g Communication Conditions
g Command format
• Commands are 3 characters following STX, finally
adding ETX.
• Add a : (colon) after the command as required, and
add the data.
g Response formats
1. Setting command response
2. Query command response
3. Error response
Error code
ER001: Invalid command
ER002: Parameter error
ER001: Invalid command
ER002: Parameter error
RS-232C terminal
PC Side
(Straight)
BT-LH2600W Side
Pin number
Signal
Pin number
Signal
1
N.C.
1
N.C.
2
RXD
2
TXD
RS-232C Terminal (9P)
3
TXD
3
RXD
4
DTR
4
DSR
5
GND
5
GND
6
DSR
6
DTR
7
RTS
7
CTS
8
CTS
8
RTS
9
N.C.
9
N.C.
RS-232C REMOTE operation method
Pin
number
Signal
name
Explanation
1
N.C.
Not connected
2
TXD
Transmission data
3
RXD
Reception data
4
DSR
Connected inside.
5
GND
Ground
6
DTR
Connected inside.
7
CTS
Connected inside.
8
RTS
Connected inside.
9
N.C.
Not connected
Signal level
Conforms to RS-232C
Synchro system
Tone pace synchro system
Transfer rate
9600 bps
Parity None
Data length
Data length
8 bit
Stop bit
1 bit
Flow control
None
STX (02h)
Command
:
Data
ETX (03h)
STX (02h)
Command
ETX (03h)
STX (02h)
Data
ETX (03h)
STX (02h)
Error code
ETX (03h)