Panasonic cf-07lzxxxxx User Manual

Page of 45
15
Battery Status
Charging
Fully-charged
Battery charge is low (the charge is less than  approx. 9%
capacity)
Battery pack or charger may not be working properly.
Quickly remove the battery pack and disconnect the AC
adaptor, then connect them again.  If the problem persists,
contact Panasonic Technical Support.
Unable to recharge due to violation of temperature limits.
(The ambient temperature is outside the allowable range.
 Once the allowable range requirement is satisfied, charg-
ing begins automatically.)
Battery is discharging to prescribed charging level in high
temperature mode.
Battery pack is not connected or charging not being per-
formed.
Battery Power
Battery Status
Battery Indicator
Orange*
1
Green*
1
Red
Blinking red*
1
Blinking orange*
1
Blinking green
Not lit
*
1
 When the AC adaptor is connected.
This computer prevents overcharging of the battery by recharging only when
the remaining power is less than approx. 95% of capacity after the battery is
fully charged.
When the remaining battery charge of the computer is between 20-80%, re-
charging starts from the battery pack inserted into the second battery pack
slot, and discharging starts from the battery pack inserted into the main bat-
tery pack slot. When the remaining battery charge of the computer is 0-20%
or 80-100%, both the main battery pack and the secondary battery pack are
recharged/discharged almost equally.
 Getting a detailed reading
Select [Start]-[Settings]-[Control Panel]-[Power Management]*
2
-
[Power Meter]
*
2
Windows 2000
: [Power Options]
The actual remaining battery capacity and the displayed indication may differ.
Use the Battery Indicator to Check on the Battery Status
NOTE
NOTE
• The battery indicator light remains red.
• The battery remaining displays 99% and
the indicator light is orange for a long pe-
riod of time.
• Low battery warning appears after a short
period of time.
This may be caused by the use of standby
mode for long periods of time.  The bat-
tery is discharging while the computer is
in standby mode when the AC adaptor is
not connected.
Perform the “Refresh
Battery” utility.
(