Panasonic BT-LH1700WP User Manual

27

If you use rack-mounting adaptors BT-MA1710G (optional) with this monitor, you can incorporate a 19-inch 
standard rack (the height is 7U size). Please see the instructions below for attachment. 

If for any reason an error occurs in this monitor, the LEDs above the picture adjusting knob flash at 1-second 
intervals (informing you of the error/warning display). 

• To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth. 

 

If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out to 
clean the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor can 
cause a malfunction. 

• Never use thinner or benzene to clean this unit. 

 

Doing so would cause the surface of the monitor to become discolored, and cause paint to peel. 

• Do not spray cleansers directly onto the monitor.

 

Water or similar substances getting inside the monitor can cause a malfunction. 

Screw

Rear view

Base

Stand

Rack-mounting adaptor

Screw

If a malfunction occurs in the inverter that 
controls the backlight brightness, the 
backlight will switch OFF. 
The screen becomes completely black. 

Switch the power supply OFF once, then 
switch it back ON again. If an error is still 
displayed, contact the vendor where you 
purchased the monitor.

 

The fan in the back of the monitor stops if 
a malfunction occurs. If a picture is being 
displayed when the malfunction occurs, it 
will continue being displayed as is. 

If the error is still displayed after this, 
contact the vendor where you purchased 
the monitor immediately. 
If a fan stop error occurs, setting “FAN 
MOTOR” to “OFF” in the “SYSTEM 
CONFIG” menu (refer to page 18) allows 
you to continue using the monitor with 
reduced screen brightness.