Panasonic cf-48v4xx User Manual
14
Operation
1
Open the display
Slide the latch as shown and lift open the display.
Starting Up/Shutting Down
Starting Up
2
Turn your computer on
Press the power switch and hold it for approximately one second until the power indicator
turns on before releasing it.
turns on before releasing it.
After confirming that the power indicator has turned on, avoid the following until
Windows has completed loading.
• Connecting or disconnecting the AC adaptor.
• Touching the power switch.
• Performing any keyboard or touch pad (or external mouse) operations.
• Closing the display.
Once the computer is powered off, you must wait at least ten seconds before pow-
ering it on again.
When the CPU temperature rises, the computer may not power on to prevent the
CPU from overheating. Should this happen, allow the computer to cool down then
switch the power on again.
If the computer still does not power on, contact Panasonic Technical Support.
Windows has completed loading.
• Connecting or disconnecting the AC adaptor.
• Touching the power switch.
• Performing any keyboard or touch pad (or external mouse) operations.
• Closing the display.
Once the computer is powered off, you must wait at least ten seconds before pow-
ering it on again.
When the CPU temperature rises, the computer may not power on to prevent the
CPU from overheating. Should this happen, allow the computer to cool down then
switch the power on again.
If the computer still does not power on, contact Panasonic Technical Support.
If security indicator (
) is displayed,
you must first enter your password (
“Security Measures”)
When an application or file that was previously displayed ap-
pears on your screen,
pears on your screen,
the standby or hibernation mode (
“Standby/Hibernation Functions”) has
been set.
Three incorrect attempts, or if no pass-
word is entered for about a minute,
word is entered for about a minute,
If the correct password is input,
Will Start
Will Not Start
(Power off)
Upon entering your password* and pressing
Enter
*
Password set in the Setup Utility (not the Windows password).
Power
Switch
Switch
2
1
Power Indicator
CAUTION