Panasonic cf-t2dwatzkm User Manual

39

<To create a backup area and divide hard disk into two partitions, for OS and data>
Select [2], enter the partition size (GB), and press   Enter   .

• You can cancel this operation by pressing    0   .
• The data partition size will be the maximum settable size less the number entered above.

The maximum settable size will differ depending on models.

9 At the confirmation message, press    Y   .

The backup area is then created.

10 When the message [You must reboot in order to enable the Backup function.] appears, remove

the recovery CD, and press any key to restart the computer. The computer is restarted, then the
backup process will begin.

11 When the message [[Backup] is complete] appears, press   Ctrl   +   Alt   +   Del    to restart the

computer.

12 A message will appear advising that a new device has been installed and that the computer must

be restarted to enable the settings.  Select [Yes] to restart the computer.

The [Boot] menu in the Setup Utility is set to start up from the DVD-ROM & CD-R/RW
drive. Change this setting if necessary.
The next time the backup or restore functions are executed, follow the procedure for [Backing
Up and Restoring Data] (

 below).

The usable hard disk area

[At the time of purchase]

[After the backup area is created]

The backup area

Cannot be accessed

from Windows.

Do not press   Ctrl   +   Alt   +   Del   until the message is displayed.

Can be accessed from

Windows (Two partitions).

1 Turn the computer on, and press   F2   while [Panasonic] boot screen is displayed.

The Setup Utility will start up.
If a password has been set, enter the Supervisor Password or the User Password.

2 Select [Exit] menu, then select [Hard Disk Backup / Restore] and press 

 Enter   .

At the confirmation message, select [Yes], and press  

 Enter   .

Before executing the backup function, execute a disk error check (

 page 37).

Do not interrupt the backup or restore functions before completion, for example by turning
off the power or pressing 

 

 Ctrl   +   Alt   +   Del  , as this may prevent Windows from starting

up, or may cause data to be lost so that the backup and restore functions cannot be executed.