Panasonic cf-51mcmddbm User Manual

10

z Be sure the AC adaptor is connected until completing the first-time use opera-

tion. 

z When using the computer for the first time, do not connect any peripheral device 

except the battery pack and AC adaptor to the computer.

z Do not twist or pull the AC power cord forcefully.  Doing so may damage the con-

nections.

z Use only the specified AC adaptor with your computer.  Using an AC adaptor 

other than the one supplied might damage the battery and/or the computer.

z When the DC plug is not connected to the computer, disconnect the AC cord 

from your AC wall outlet.

z Problems such as sudden voltage drops may arise during periods of thunder 

and lightning.  Since this could adversely affect your computer, an uninterrupt-
ible power source (UPS) is highly recommended unless running from the battery 
pack alone.

A Slide the latch located at the front.
B Lift open the display. 

Press the power switch 

 and hold it for approximately one second until the 

power indicator 

 turns on before releasing it.

z Do not press the power switch repeatedly.
z Once the computer is powered off, you must wait at least ten seconds 

before powering it on again.

Moving the cursor 

 or clicking buttons can be performed with the touch 

pad.

 (Πpage 16)

z Do not press any key or move the touch pad until [Windows XP Profes-

sional Setup] is displayed.

A At [Welcome to the Windows XP Setup Wizard], select [Next].
B After reading the agreement, select [I accept this agreement] or [I don’t 

accept this agreement], then select [Next].
z If [I don’t accept this agreement] is selected, the Windows setup will be 

aborted.

C Select settings for your region, then select [Next]. 
D Enter your name and organization and then select [Next]. 
E Enter your computer name and administrator password and then select 

[Next]. 
z Remember this password!  If the password is forgotten, Windows can-

not be operated.

F Enter the correct date, time and the time zone, then select [Next]. 

The computer will restart.
z It may take some time before the computer restarts and the screen of 

step 

i

 is displayed.  Wait, and do not press any keys, or touch the 

touch pad, etc.

G Enter your administrator password and select 

.

z When Windows setup is completed, the following message will be 

displayed at the bottom right of the screen: “Your computer might be at 
risk.”  Continue to the next step.
The message is generated by the [Security Center] function in [Control