Panasonic cf-y2 User Manual

46

<When the hard disk backup function has been enabled>
If you select [3] in step 

 (

 page 38) and execute reinstallation, the drive name for the second

partition (data partition) may be switched with that of the SD Memory Card.  You can still use the
drives after the names have been switched, but you can also return the drive names to their original
state using the following procedures.
(The following procedure assumes that before reinstallation, the second partition (data partition)
was Drive D:, and the SD Memory Card was Drive E:)

Disable the drive name for the second partition (data partition).

1

In the menu below, select [Computer Management].

Select [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools].

2

Select [Disk Management].

3

Right click on the partition for which [E:] is displayed and select [Change Drive Letter and
Paths...].

4

Select [Remove].

5

At the confirmation message, select [Yes].

Change the SD memory card drive name to [E:].
Use the SD drive name change tool to change the SD Memory Card to the E: drive. (

 

"SD Memory Card/ MultiMedia Card").

Set the drive name for the second partition (data partition) as [D:].

1

In the menu below, select [Computer Management].
Select [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools].

2

Select [Disk Management].

3

Right click on the partition for which the drive name is not displayed, and select [Change
Drive Letter and Paths...].

4

Select [Add...], assign [D:] as the drive letter, and select [OK].