Panasonic cq-2130 User Manual

18

❐ Preparation

❐ Installation Hardware

If your vehicle is equipped with air bag

and/or anti-theft systems, specific procedures may
be required for connection and disconnection of the
battery to install this product.
Before attempting installation of this electronic com-
ponent, contact your vehicle dealer or manufacturer
to determine the required procedure and strictly fol-
low their instructions. 
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE
AND PERSONAL INJURY.

Various settings that have been stored in

the memory in other on-board equipment (vehicle
navigation etc.) may be lost if the battery terminals
are disconnected.
Therefore, we recommend to make a record of or to
back up the settings before disconnecting the termi-
nals.
After completing installation of the main unit, set the
equipment again according to the record.

• Disconnect the cable from the negative 

battary ter-

minal (see warning and caution below).

• Remove Mounting Collar 

q from the main unit tem-

porarily, which are already mounted at shipment.*

• Unit should be installed in a horizontal position with

the front end up at a convenient angle, but not more
than 30˚.

❐ Dashboard Installation

Installation Opening
This unit can be installed in any dashboard having an
opening as shown below. The dashboard should be
3/16” (4.75 mm) – 7/32” (5.56 mm) thick in order to be
able to support the unit.

q

1

Mounting Collar*

Plain washer (5mmø)

w

2

Spring Washer (5mmø)

e

2

Hex. Nut (5mmø)

r

2

Rear Support Strap

t

1

Hex. Bolt
(5mmø 

× 25 mm)

y

1

Toothed Lock Washer
(5mmø)

u

1

Removal Tool
(U-shaped)

i

2

Antenna Connector

o

1

Mounting bolt
(5 mmø)

q Mounting collar

 Rear support bracket
(provided on the vehicle)

Rubber cushion (option)

t