Panasonic cq-2130 User Manual
CQ-2130U
8
Alarm Time Setting
CLK
ALM
PRG
LOUD
APM
BAND
PWR
VOL
SEL
CQ-2130U
PUSH
BASS/TREB
BAL/FADER
MUTE
6
5
4
3
2
1
SCAN
TUNE
SEEK
ILL
TUNE
SEEK
ALM
The 12-hour system is used for the clock.
Initial Alarm Time
Press and hold [ALM] (Alarm)
“AM 12:00” is displayed when the alarm is not adjusted.
[}] (Minutes)
[{] (Hours)
Alarm Time Setting
Hours
Minutes
Alarm Time Reset
When you want to reset the alarm time, repeat
steps
steps
q to r.
Alarm Operation
• Alarm is switched to ON or OFF each time [ALM] is pressed.
• When the alarm is switched to ON, the alarm will sound at the set
• When the alarm is switched to ON, the alarm will sound at the set
alarm time.
Turning off the Alarm Sound
The alarm will turn off automatically after 90 seconds. Otherwise,
press [ALM] once.
The alarm will turn off automatically after 90 seconds. Otherwise,
press [ALM] once.
Alarm output Volume Selection
You can select ALARM VOL 1 (or VOL 2) by pressing [ALM] in
sequence and the display will show as follows.
sequence and the display will show as follows.
q Press and hold [ALM] (Alarm) and do not
release to set alarm time. Display blinks and
the alarm time setting mode is activated.
the alarm time setting mode is activated.
w Press [{] to set the hour.
e Press [}] to set the minute.
r Once the alarm time has been set, release
[ALM].
Note: Press and hold [{] or [}] to change
numbers rapidly.
(blink.)
(Hours set.)
(Minutes set.)
Cautions:
• Be careful not to set wrong alarm time, otherwise, the alarm
• Be careful not to set wrong alarm time, otherwise, the alarm
may sound while driving.
• If the alarm is set, be sure to check the set alarm time by
pressing [CLK].
• If volume is set at “0” level, the output volume will be muted.
(Even when ALARM is acting.)
a
a
OFF