Panasonic cq-c5210u User Manual
22
CQ-C5410/5310/5210/5110U
CQ-C5410/5310/5210/5110U
23
Volume
Note:
≥ The volume level can be set independently for
≥ The volume level can be set independently for
each source. (For radio, one volume setting for
AM, one volume setting for all FMs)
AM, one volume setting for all FMs)
Setting range: 0 to 40
(default: 18)
(default: 18)
[VOL
"]: Up
[VOL
#]: Down
Down
Up
General
Source
E
N
N
G
L
I
S
H
H
4
E
N
N
G
L
I
S
H
H
3
Mute/Attenuation
ON:
Press [MUTE]. ( lights.)
OFF:
Press [MUTE] again.
You can select mute or attenuation. (page 40)
Power
Turn your car’s ignition key
to the ACC or ON position.
to the ACC or ON position.
ON: Press [SOURCE] (PWR).
OFF:
Press and hold [SOURCE] (PWR) until you
hear a beep (about 1 second), then release
it.
hear a beep (about 1 second), then release
it.
Press [SOURCE] (POWER) again and hold
for more than 1 second.
for more than 1 second.
Note:
≥ After turning off the ignition key, a security
message is displayed, and the panel removable
alarm that reminds you to take the panel is
activated.
(When security function is set on to on, page 40)
alarm that reminds you to take the panel is
activated.
(When security function is set on to on, page 40)
ACC
ON
Demonstration:
When the power is switched on for the fi rst time,
a demonstration appears on the display.
Press [DISP] (display) to change to regular
mode.
When the power is switched on for the fi rst time,
a demonstration appears on the display.
Press [DISP] (display) to change to regular
mode.
Note:
≥ To display the demonstration again, press and
≥ To display the demonstration again, press and
hold [SOURCE] for more than 4 seconds when
turning power on.
turning power on.
6
4
9
7
5
Car Audio
SOURCE
MUTE
POWER
RAND
VOL
3
1
2
DISP
BAND
REP
6
5
SET
SEL
#
SCAN
MENU
NUMBER
8
0
[DISP]
(Display)
(Display)
[SOURCE]
(Power/source)
(Power/source)
[MUTE]
[VOL
"]
[VOL
#]
(Volume)
[SOURCE]
(PWR: power)
(PWR: power)
Press [SOURCE] to change the source.
[MUTE] (Mute/attenuation)
(SBC-SW)
(SBC-SW)
[VOLUME]
CQ-C5410U
CQ-C5310U
Radio (page 26)
CD player (page 29)
When a MP3/WMA data disc
is in the player.
is in the player.
MP3/WMA player (page 30)
When an optional CD changer
is connected.
is connected.
CD changer control (page 34)
AUX (page 57)
or
CQ-C5210U
CQ-C5110U
Radio (page 26)
CD player (page 29)
When an optional CD changer
is connected.
is connected.
CD changer control (page 34)
No sounds. (default)
Decrease the volume by 10 steps.
[DISP] (Display)
Scrolling
Level meter
(This varies the display
in line with the volume level.)
(This varies the display
in line with the volume level.)
Point the remote control unit at the remote control signal sensor.
Spectrum analyzer
(This shows two sets of levels for each of the following frequencies
in sequence starting from the left: 60 Hz, 160 Hz, 400 Hz, 1 kHz,
3 kHz, 6 kHz, 16 kHz.)
(This shows two sets of levels for each of the following frequencies
in sequence starting from the left: 60 Hz, 160 Hz, 400 Hz, 1 kHz,
3 kHz, 6 kHz, 16 kHz.)
indicator
Rear Speakers as Sub-Woofers
(Super Bass Control Subwoofer/SBC-SW)
You can utilize the rear speaker connected to the
built-in amplifi er as Sub-Woofers that output only
bass.
built-in amplifi er as Sub-Woofers that output only
bass.
Press and hold [MUTE] (SBC-SW) for more than
2 seconds.
2 seconds.
CQ-C5410U
CQ-C5210U
Note:
≥ When ON has been selected, the settings resulting
≥ When ON has been selected, the settings resulting
from the adjustments performed at the subwoofer
level and subwoofer low pass fi lter settings are
refl ected in the output.
level and subwoofer low pass fi lter settings are
refl ected in the output.
≥ Depending on the speakers used and the type of
music played, it may not be possible to achieve a
satisfactory effect.
satisfactory effect.
OFF
(Default)
(Default)
ON
( lights.)
( lights.)