Panasonic cq-dfx972n User Manual

u

Lock Cancel Plate

2

q

w

e

r

t

y

Mounting Collar

Mounting Bolt (5 mmø)

Power Connector

Removable Face Plate Case

Trim Plate

ISO Antenna Adapter

1

1

1

1

1

1

30

Fire Wall of Car

Hex. Nut (Option)

Rear Support Strap (Option)

w Mounting Bolt

q Mounting Collar

Tapping Screw (Option)

3 mmø

Rubber Cushion 
(Option)

w Mounting Bolt

q Mounting Collar

Rear Support Bracket
(Provided on the car)

Caution: Do not disconnect the battery terminals of a
car with trip or navigational computer since all user 
settings stored in memory will be lost.  Instead take
extra care with installing the unit to prevent shorts.

¡Before installation, check the radio operation with 

antenna and speakers.

¡Disconnect the cable from the negative (–) battery 

terminal (see caution below).

¡Unit should be installed in a horizontal position with the

front end up at a convenient angle, but not more than
30°.

Installation Opening
The unit can be installed in
any dashboard having an
opening as shown at right.
The dashboard should be
4.5 mm - 6 mm thick in order to be able to support the
unit.

Installation Precautions
This product should be installed by a professional
installer, if possible.
In case of difficulty, please consult your nearest authorized
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery

system (car) with negative ground.

2. Follow the electrical connections carefully (

a

Page 34).

Failure to do so may result in damage to the unit.

3. Connect the power lead (red) after all other connections

are made.

4. Be sure to connect the battery lead (yellow) to the 

positive terminal (+) of the battery or fuse block (BAT)
terminal.

5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation

instructions of the respective equipment before 
connecting it to this unit.

182 mm

53 mm

30° or less