Panasonic cs-sa9ckp User Manual

Page of 10
ENGLISH
6
Pre-season Inspection
Is the discharged air cold/warm?
Operation is normal if 15 minutes after the start of
operation, the difference between the air intake
and outlet vents temperature is:-
Cooling  –  8˚C or above
Heating  –  14˚C or above
Are the air intake or outlet vents of the indoor
or outdoor units obstructed?
Are the remote control batteries weak?
If the remote control display appears weak, replace
the batteries.
When the Air Conditioner is Not To Be  Used
for an Extended Period of Time
1
To dry the internal parts of the indoor unit, operate
the unit for 2 – 3 hours using:
Operation mode : cooling
Set temperature : 30˚C
2
Turn off the power supply and unplug.
3
Remove the remote control batteries.
Recommended Inspection
After used over several seasons, the unit will
become dirty and thus decreases the unit's
performance. Depending on the operation
conditions, a dirty unit may produce odour and dust
may pollute dehumidification system. Therefore, a
seasonal inspection is recommended in addition to
regular cleaning. (Consult an authorized dealer).
HELPFUL INFORMATION
Auto Operation Button
Automatic Operation
If the remote control fails to function or has been
misplaced, press the Auto Operation button to start
the Automatic operation.
The Automatic operation will be activated
immediately once the Auto operation button is
pressed. However, temperature cannot be adjusted
in this operation.
The power indicator on the indoor unit will blink
until the operation mode is selected automatically.
To cancel this operation, press this button once more.
Remote Control Signal Receiving Sound
To switch off the beep (Signal Receiving Sound),
press the Auto Operation button for 10 seconds
continuously or longer.
Repeat the above steps if you want to switch on
the Signal Receiving Sound.
Timer Setting
When power failure occurs, the timer setting will be
cancelled. Once power is resumed, reset the timer.
Thunder and Lightning
This air conditioner is equipped with a built-in
surge protective device. However, in order to
further protect your air conditioner from being
damaged by abnormally strong lightning activity,
you may switch off the main power supply and
unplug from power socket.
AUTO
TEST RUN
SOUND
5 seconds
10 seconds
1 Beep
2 Beep
ENERGY SAVING AND OPERATION
HINTS
Setting the Temperature
Set the temperature higher or lower than the
desired temperature.
Cooling Operation : 1˚C higher
Heating Operation : 2˚C lower
Approximately 10% of electricity can be saved.
Air Filters
Clean the air filters every 2 weeks.
Dirty filters may reduces cooling or heating
efficiency.
Keep All Doors and Windows Closed
Otherwise, cooling or heating performance will be
reduced and electricity cost is wasted.
Outdoor Unit
Do not block the air outlet vent. Otherwise, it will
lower the cooling or heating performance.
Avoid Direct Sunlight
Keep curtains or drapes closed to avoid direct
sunlight during cooling operation.
AUTO
ON
F563553/01-08/EN
5/6/02, 10:34 am
7