Panasonic dmr-e100heb User Manual

∫ Helpful Hints

PDC (Programme Delivery Control)
Programme Delivery Control adjusts the start and stop time of a 
timer recording automatically to ensure the recording starts and 
finishes in line with the programme broadcast. This is useful when 
a programme over-runs the published times. 
The station must be transmitting PDC and the exact time must be 
set for PDC to work. 

The unit detects whether a station is transmitting PDC only during 
the tuning process. 
If PDC is introduced or discontinued by a station you will need to 
re-tune the unit before it becomes aware of this. 
PDC transmissions are not currently nation-wide so please check 
with your local broadcaster for more information.
The beginnings of recordings may not be recorded correctly in 
some cases.

DVD-Video are divided into large sections (titles) and smaller 
sections (chapters). The numbers allocated to these sections are 
called title numbers and chapter numbers.

(1) Title 1
(2) Title 2
(3) Chapter 1
(4) Chapter 2
(5) Chapter 3

This is the smallest division on CD, and Video CD.

(1) Track 1
(2) Track 2
(3) Track 3
(4) Track 4
(5) Track 5

(1)

(2)

(3)

(4)

(3)

(4)

(5)

(1)

(2)

(3)

(4)

(5)

The disc is dirty or badly scratched.

≥Follow the instructions in “Maintenance and Handling” to clean the disc if it is 

dirty.

≥The disc is not available if it is scratched and this display doesn’t disappear.

–

It can not be read for the disc which 
doesn’t cope with it.

≥Exchange a disc.

–

The DVD-RAM/PD lens cleaner 
has finished cleaning.

≥Take the cleaner out of the unit.

–

UNSUPPORT You have inserted a disc the unit 

cannot play or record on.

≥Insert a disc the unit can play or record on. 

The unit is hot.

≥The unit switches to standby automatically for safety reasons and cannot be 

operated. Wait for about 30 minutes for the service number to disappear.

≥Select a position with good ventilation when installing the unit.
≥Do not block the cooling fan on the rear of the unit.

–

–
–

The unit fails to operate properly.

≥Press [Í/I] to switch the unit to standby. Now press [Í/I] again to turn the 

unit on.

–

The remote control and main unit 
are using different codes.

≥Change the code on the remote control or main unit.

A power failure occurred or the AC 
mains plug was disconnected while 
the power was ON. However, self 
check is also activated when this 
unit is normally turned on.

≥The unit is carrying out its recovery process. Wait until the message 

disappears.

–

The HDD is paused to extend its 
lifetime.

≥Press [HDD] to start.

–

DVD(B).book  68 ページ  ２００３年８月５日 火曜日 午後３時３０分