Panasonic dmr-e95h User Manual
50
RQT7392
Con
v
e
n
ie
n
t func
tions
Channel/Clock settings when TV Guide On Screen
TM
system is not used
Refer to the control reference on page 47.
Preparation:
If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below.
If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below.
When the unit is on and stopped
1
Press and hold [
X
CH] and [
W
CH] on the main unit for about five seconds.
The unit turns off.
2
Press [
Í
DVD POWER] to turn the unit on.
3
Complete the TV Guide On Screen
TM
system setup (until [ENTER] is pressed after the “Watch
TV” message screen is displayed).
[Note]
You can set timer recording only manually after you set the unit with “Auto Channel Setting”.
1
Press [SETUP].
2
Press [
3
,
4
] to select “Channel” and
press [
1
].
3
Press [
3
,
4
] to select “Auto Channel
Setting” and press [ENTER].
4
Press [
2
,
1
] to select “Yes” and
press [ENTER].
5
Press [ENTER].
Auto Channel Setting starts. This takes a few minutes.
The unit then proceeds with Auto Clock Setting. The time is
displayed when finished.
The unit then proceeds with Auto Clock Setting. The time is
displayed when finished.
≥
DST, Daylight Saving Time, shows the summertime setting.
≥
TIME ZONE shows the time difference from Greenwich
meantime (GMT).
EST (Eastern Standard Time)
l
GMT
j
5
CST (Central Standard Time)
l
GMT
j
6
MST (Mountain Standard Time)
l
GMT
j
7
PST (Pacific Standard Time)
l
GMT
j
8
AST (Alaska Standard Time)
l
GMT
j
9
HST (Hawaii Standard Time)
l
GMT
j
10
For other areas: xx hr
≥
If the Auto Clock Setting does not start automatically, select
“Auto Clock Setting” from the “Set Up” tab.
≥
If the time was not set correctly, use manual clock setting
(
➡
page 11) or time zone adjust.
6
Press [ENTER].
≥
The unit configures channels according to the Antenna
System settings as follows.
Adjust the time zone (
j
1 or
i
1) if it was not set correctly with auto
clock setting.
You cannot change this setting if you set the clock manually.
You cannot change this setting if you set the clock manually.
1
Press [SETUP].
2
Press [
3
,
4
] to select “Set Up” and
press [
1
].
3
Press [
3
,
4
] to select “Time Zone
Adjust” and press [ENTER].
4
Press [
3
,
4
] to select “
s
1” or “
r
1”
and press [ENTER].
To exit the screen
Press [SETUP].
Press [SETUP].
To return to the previous screen
Press [RETURN].
Press [RETURN].