Panasonic gp6d th-42px20u th-50px20u th-42pa20u th-37pa20u update information Service Manual
NTSC White Balance Adjustment
Equipment required: NTSC Pattern Generator, Colorimeter
Panel Settings; Picture = Standard, Color Temperature = Cool, Aspect Ratio =
16:9
Step 1- Using the Pattern generator; apply a 20
IRE Window pattern signal to the panel. Apply the
color sensor to the panel and monitor the values.
IRE Window pattern signal to the panel. Apply the
color sensor to the panel and monitor the values.
20 IRE Window
pattern
Step 2- Adjust the Sub Bright Setting to 10 cd/m
2
.
Step 3- Set the G Cutoff Setting Value to 80.
Step 4- Adjust the Red and Blue Cutoff settings to
match the values in Table 1.
Step 5- Readjust the Sub Bright setting to 10
cd/m
Step 4- Adjust the Red and Blue Cutoff settings to
match the values in Table 1.
Step 5- Readjust the Sub Bright setting to 10
cd/m
2
.
Step 6- Apply an 80 IRE window pattern signal to
the Panel.
the Panel.
80 IRE Window
pattern
Step 7- Set the G Drive Setting value to E8.
Step 8- Adjust the Red and Blue Drive settings to
match the values in Table 1.
Step 9- Reapply the 20 IRE pattern and 80 IRE
patterns and verify that the drive and cutoff
settings match the settings in Table 1, adjust as
necessary.
Step 10- Adjust the All Drive Settings value to FC.
Step 11- Reapply the 20 IRE pattern and verify the light settings match the
table below, adjust as necessary.
Step 8- Adjust the Red and Blue Drive settings to
match the values in Table 1.
Step 9- Reapply the 20 IRE pattern and 80 IRE
patterns and verify that the drive and cutoff
settings match the settings in Table 1, adjust as
necessary.
Step 10- Adjust the All Drive Settings value to FC.
Step 11- Reapply the 20 IRE pattern and verify the light settings match the
table below, adjust as necessary.
Table 1
Color Temperature
X
Y
Cool (High)
0.276
0.276
Normal (Mid)
0.288
0.296
Warm (Low)
0.313
0.329
Step 12- Press the R button then the Picture button on the remote control.
Change the color temperature to Normal. Press the R button again then
the Action button to re-access the IIC mode.
Step 13- Repeat steps 2 to 11 for Normal Color Temperature.
Step 14- Press the R button then the Picture button on the remote control.
Change the color temperature to Warm. Press the R button again then
the Action button to re-access the IIC mode.
Step 15- Repeat steps 2 to 11 for Warm Temperature.
Step 16- Change the Color temperature to Cool Mode, then re-adjust the
Sub bright value to “30”.
64