Panasonic sa-ht1000 User Manual

RQT7061

This mode is useful if you have to place your 
surround speakers near the front speakers due 
to the layout of your room.
This mode makes it seem like the sound from 
the surround speakers is coming from behind 
you.

r[MULTI REAR] for 

Each time you do this:

V.R.S ON

!)

V.R.S OFF

This mode makes it seem like sound is coming 
from multiple rear surround speakers virtually 
when connected with surround speakers.

r[MULTI REAR].

Each time you do this:

M.R.S ON

!)

M.R.S OFF

Using this function makes you feel like you are 
sitting in the ideal seating position (in the center of 
the circle formed by the speakers), even if you 
cannot due to the layout of your room.

r[S.POSITION].

3, 4, 2,  1] to select a 

To cancel
Press [SHIFT]

r[S.POSITION] again.

[Note]

While virtual rear surround is on, the seat position is changed in 
three horizontal steps.

Each time you press the button:
SUB W 1

>SUB W 2>SUB W 3>SUB W 4 (factory preset)

 ^-------------------------------------------------------------}

Adjust the level of the speakers so they are the same apparent level 
as the front speakers where you would normally be sitting and 
listening. (L, R 

➡below, Balance)

Preparation
≥Dolby Digital and DTS: Turn off the other sound field systems.
≥Dolby Pro Logic II: Press [SHIFT]i[ÎPRO LOGIC II].

r[TEST] to output a test signal.

Lch: Front left
Cch: Center
Rch: Front right
RSch: Right surround
LSch: Left surround

r] or [s] to set the volume level normally 

3] (to increase) or [4] (to decrease).

L, R: (

➡below, Balance)

C, RS, LS: 

j6 dB to i6 dB

To stop the test signal, press [SHIFT]

i[TEST] again.

∫ To adjust speaker level during play

r[CH SELECT] to select the speaker. 

L

R

>Cch>RSch>LSch>SWch

^---------------------------------------------------}

SW: Subwoofer
≥You can only adjust SW if there is output from the subwoofer 

channel.

3] (to increase) or [4] (to decrease).

L, R: (

➡below, Balance)

C, RS, LS:

j6 dB to i6 dB

SW: 

j6 dB to i6 dB

You can adjust the balance of the front speakers.
1 Press [SHIFT]

r[CH SELECT] to select “L R”.

2, 1] to adjust the “L”, “R” balance.

Virtual speakers

Virtual speakers

7061en.book  37 ページ  ２００３年７月１日　火曜日　午前１１時４４分