Panasonic KX-PS8100 User Manual

When an error interferes with printing (or) scanning, you will see a message 
on the LCD panel. The following table lists the messages in alphabetical 
order, with the appropriate corrective action for each one.

The following status messages cause the ERROR indicator to blink. 
Scanning/printing will continue when corrective action (if required) is taken, 
and the READY indicator is lit.

•

If the message indicates that you don’t have enough memory to finish 
duplicating or printing, you may need to install additional memory to 
handle your workload. 

The back of the 
printed page 
appears dirty.

Toner particles have contaminated the transfer 
roller. This can happen if the printed image is larger 
than the media (for example, when printing on 
envelopes). Run 10-20 prints to clean the transfer 
roller.

The cleaning pad may get dirty with toner. Replace 
the cleaning pad. (

of 

Setup Manual.)

The print quality of 
a transparency is 
poor.

Make sure that you have selected the correct 
media.

Make sure that you are using the recommended 
media (CG3710).

Make sure that you are printing on the taped side, if 
you are using CG3710.

ADF open.

Close the ADF.

ADF is open.

Close the ADF.

ADF paper Jam.

A jam has occurred in ADF.

Open the ADF top cover, remove the 
jammed document.