Panasonic KX-HCM10 User Manual
Operating Instructions
68
2.
When you need to reset to Factory Default, click the
button.
The Reset to Factory Default button allows you to initialize all the parameters
of the Network Camera to the factory default, including the ID, Password, IP
Address and Subnet Mask.
of the Network Camera to the factory default, including the ID, Password, IP
Address and Subnet Mask.
•
To undo the reset click
.
Then it returns to Setup Page, without reset to Factory Default.
CAUTION
1.
Buffered images are erased when you execute this page.
2.
Never turn off the power, during the Reset to Factory Default.
3.
Please refer to "Getting Started Manual" to open this Network Camera, after
execute this page. Because setting condition will be changed. Especially,
execute this page. Because setting condition will be changed. Especially,
IP Address : Changed to 192.168.0.253
Subnet Mask : Changed to 255.255.255.0
Subnet Mask : Changed to 255.255.255.0
Information
•
Please refer to Section 3.2
•
You can also operate the "Reset to Factory Default" by pushing the
"CLEAR SETTING button" a few seconds, located on the side panel.
Please refer to Section 3.2 about the "CLEAR SETTING button"
"CLEAR SETTING button" a few seconds, located on the side panel.
Please refer to Section 3.2 about the "CLEAR SETTING button"
Execute
Cancel