Panasonic kx-tcd955 User Manual
Chapter 4
45
Multi-Unit User Operations
Registration
Registering a Handset in the Base Unit
You must register the handset in the base unit before use.
1
Handset:
Press .
Press .
2
Press
G or F until the arrow points to
“
Program
”, then press
OK
H
.
3
Base unit where handset is to be
registered:
Press and hold
registered:
Press and hold
on the base unit
for more than 10 seconds until the in
use indicator (
use indicator (
) lights and a
confirmation tone sounds.
4
Handset:
Press
Press
G or F until the arrow points to
“
Registration
”, then press
OK
H
.
5
Press
G or F until the arrow points to
“
Register H/set
”, then press
OK
H
.
•
The available base unit numbers are
displayed.
displayed.
6
Press
G or F to select the desired
base unit number 1 to 4, then press
OK
H
.
•
The number is assigned as the base unit
number for the handset.
number for the handset.
F
•
Charge the optional handset batteries for about 4 hours before initial use.
•
Make sure that the power is ON (p. 12) and the unit is in the stand-by mode.
•
Register the handset number within 1 minute. If not registered within 1 minute, press
on the
handset to cancel the programming mode. Then start again from step 1.
C
7
Enter the base unit password (p. 35).
8
Press
OK
H
.
•
“
Please Wait...
” is displayed, then
a confirmation tone sounds.
•
The handset will return to the stand-by
mode. The current connected base unit
number will be displayed.
mode. The current connected base unit
number will be displayed.
•
The in use indicator (
) on the base
unit will go out.
•
To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
base unit, repeat from step 1 with the
other base unit(s).
•
You can exit the programming mode any time
by pressing
by pressing
.
•
The base unit number which the handset is
currently in contact with can be displayed in
the stand-by mode (p. 50). Calls (both
incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio
areas overlap with neighbouring base units).
currently in contact with can be displayed in
the stand-by mode (p. 50). Calls (both
incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio
areas overlap with neighbouring base units).
C
0 N e w C a l l s
B a s e 2
P l e a s e W a i t . . .
E n t e r B a s e P I N
: —
: —
KX-TCD955EC(038~047) 99.7.15 2:50 PM Page 45