Panasonic KX-TCD735ALM User Manual
85
Chapter 5
Answering System
Setting the Monitor Function ON/OFF
When your greeting message is being played to the caller and caller is recording a message, you can
listen to it through the handset and the base unit speaker. To listen to your greeting, set to 2 (ON). The
factory preset is 2 (ON).
listen to it through the handset and the base unit speaker. To listen to your greeting, set to 2 (ON). The
factory preset is 2 (ON).
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1
Press .
2
Press
or
until the arrow points
to “
Setting Base
”, then press
.
•
“
Input Command
” is displayed.
3
Press .
•
“
Remote Operation
” is displayed.
4
Press .
•
The current setting is displayed.
5
To set to ON, press
.
OR
To set to OFF, press
To set to OFF, press
.
•
The setting is displayed.
6
Press .
•
The display will return to “
Setting
Base
”. To return to the standby mode,
press .
•
You can exit the programming mode any time
by pressing
by pressing
.
1
2
4
Selecting the Caller’s Recording Time
You can select “1 minute”, “unlimited” (a caller can record more than 1 minute–16 minutes) or
“greeting only” for the caller’s recording time. The factory preset is “unlimited”. A pre-recorded greeting
message (p. 17) depends on selecting the caller’s recording time. If you select “greeting only” and set
the answering system ON, the unit will answer a call with the greeting message, then hang up. The
unit does not record any incoming messages.
“greeting only” for the caller’s recording time. The factory preset is “unlimited”. A pre-recorded greeting
message (p. 17) depends on selecting the caller’s recording time. If you select “greeting only” and set
the answering system ON, the unit will answer a call with the greeting message, then hang up. The
unit does not record any incoming messages.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1
Press .
2
Press
or
until the arrow points
to “
Setting Base
”, then press .
•
“
Input Command
” is displayed.
3
Press .
•
“
Remote Operation
” is displayed.
4
Press .
•
The current setting is displayed.
3
5
Press , or to
select
the
recording time.
1: 1 minute 2: unlimited (16 minutes)
3: greeting only
3: greeting only
•
The setting is displayed.
6
Press .
•
The display will return to “
Setting
Base
”. To return to the standby mode,
press .
•
You can exit the programming mode any time
by pressing
by pressing
.
3
2
1
KX-TCD735ALM(E)-4(76~100) 2002.06.21 5:30 PM Page 85