Panasonic kx-tcd240fx User Manual
Useful Information
62
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Initial settings
Problem
Cause & solution
w
is flashing.
L
The handset is not registered to the base unit.
Register it (page 53).
Register it (page 53).
L
The handset is too far from the base unit. Move
closer.
closer.
L
The AC adaptor is not connected. Check the
connections.
connections.
L
You are using the handset or base unit in an area
with high electrical interference. Locate the handset
and base unit away from interference sources, such
as antenna and mobile phones.
with high electrical interference. Locate the handset
and base unit away from interference sources, such
as antenna and mobile phones.
The handset display is blank.
L
The handset is not turned on. Turn the power on
(page 13).
(page 13).
The handset will not turn on.
L
Make sure that the batteries are installed correctly
(page 12).
(page 12).
L
Fully charge the batteries (page 12).
L
Clean the charge contact and charge again (page
12).
12).
TCD230-240FX(e).book Page 62 Wednesday, June 8, 2005 7:15 PM