Panasonic KX-TG2238S User Manual

 

The unit does not work.

• Check the settings (p. 8–9).
• Check whether the dialing mode setting is 

correct (p. 12).

• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again 

(p. 9).

• Install the battery properly (p. 8).
• Place the handset on the base unit and 

unplug the AC adaptor to reset it. Plug in, and 
try again.

• Re-install the battery (p. 8) and charge it fully.

“

 

No link to base. Place 

on cradle and try 

again.

 

” is displayed and an 

alarm tone sounds.

• You are too far from the base unit. Walk 

closer and try again.

• Place the handset on the base unit and try 

again.

• Plug in the AC adaptor.
• Raise the base unit antenna.

Static, sound cuts in/out, 
fades. Interference from other 
electrical units.

• Move the handset and the base unit away 

from other electrical appliances (p. 3).

• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 19, 34).

The handset and/or base unit 
does not ring.

• The ringer volume is set to OFF. Set to HIGH, 

MEDIUM or LOW (p. 16).

• When the handset is on the base unit, the 

handset does not ring. Only the base unit 
rings when receiving a call.

The handset display is blank.

• Charge the battery fully (p. 8).

You cannot program function 
items.

• Programming is not possible while the unit is 

being used.

• Do not pause for over 60 seconds while 

programming.

• Walk closer to the base unit.

Previously programmed 
information is erased.

• If a power failure occurs, programmed 

information may be erased. Reprogram if 
necessary.

✷✸✸✿✤✦✪✪✿✮ ❃ ✧✧