Panasonic kx-tg8222e User Manual

Page of 56
Multi-unit Operation
40
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Operating additional 
units
Additional handsets
Up to 6 handsets can be registered to a 
single base unit.
Important:
L
The additional handset model 
recommended for use with this unit is 
noted on page 4. If other model 
handset is used, certain operations 
(handset settings, base unit settings, 
etc.) may not be available.
L
Additional handsets will give you the 
freedom to, for example, have an 
intercom call with another handset 
while a third handset is on an outside 
call.
Additional base units
Handsets can be registered to up to 4 
base units, allowing you to add 
additional base units and extend the 
area in which your handset(s) can be 
used. If a handset moves out of range of 
its base unit when “Auto” is selected on 
base unit selection (page 41), it will look 
for another base unit to make or receive 
calls. A base unit and the handsets it 
communicates with is called a “radio 
cell”.
Note:
L
Calls will be disconnected when the 
handset moves from one radio cell to 
another.
Registering a handset 
to a base unit
The supplied handset and base unit are 
pre-registered. When you purchase an 
additional handset, refer to the additional 
handset’s installation manual for 
registration. If for some reason the 
handset is not registered to the base unit 
(for example, w flashes even when the 
handset is near the base unit), register 
the handset.
1
"
 (centre of joystick) i N i 
#
2
{^}
/{V}: “Registration” i #
3
{^}
/{V}: “Register H.set” i 
#
4
{^}
/{V}: Select a base unit number. 
i
 #
L
This number is used by the 
handset as a reference only.
5
Proceed with the operation for your 
model.
■ KX-TG8200/KX-TG8202
Press and hold {x} on the base 
unit for about 5 seconds. (No 
registration tone)
■ KX-TG8220/KX-TG8222
Press and hold {x} on the base 
unit for about 5 seconds, until the 
registration tone sounds.
L
If all registered handsets start 
ringing, press {x} to stop, then 
repeat this step.
L
After pressing {x}, the rest of this 
procedure must be completed 
within 90 seconds.
6
Wait until “Enter Base PIN” is 
displayed. i Enter the base unit 
PIN (default: “0000”). i #
L
If you forget your PIN, see page 
50.
TG8200_20E.book  Page 40  Monday, June 18, 2007  9:03 AM