Panasonic nv-gs22ege User Manual

Others

ª LCD Monitor/Viewfinder/Lens Hood

LCD Monitor
≥In a place with drastic temperature changes, 

condensation may form on the LCD Monitor. 
Wipe it with soft dry cloth.

≥If your Movie Camera is extremely cold when 

you turn its power on, the image on the LCD 
Monitor is slightly darker than usual at first. 
However, as the internal temperature increases, 
it goes back to the normal brightness.

Viewfinder
≥Do not direct the Viewfinder or Lens to the sun. 

Internal components may be seriously 
damaged.

≥When the Movie Camera is used with a large 

capacity Battery (CGA-DU14, CGA-DU21; 
optional) attached to it, it is not practical to look 
in the Viewfinder from behind the Battery.

Lens Hood
≥Do not attach other conversion lenses in front of 

the Lens Hood; there is no mount to be used for 
the attachment.

≥When you wish to attach the Tele Conversion 

Lens (VW-LT2714N2E; optional), Wide 
Conversion Lens (VW-LW2707N2E; optional), 
MC Protector (VW-LMC27E; optional), or ND 
Filter (VW-LND27E; optional), first of all, turn 
the Lens Hood counterclockwise. If the MC 
Protector or ND Filter is used, the Lens Hood 
can be mounted on the filter.

≥If you push the [W/T] Lever toward [W] during 

recording with the filter and conversion lens 
attached together to the Movie Camera, 
4 corners of the image may become dark 
(vignetting). For details, please refer to the 
operating instructions of your accessories.

Extremely high precision technology is 
employed to produce the LCD Monitor 
screen featuring a total of approximately 
123,000 pixels. The result is more than 
99.99% effective pixels with a mere 0.01% of 
the pixels inactive or always lit. However, 
this is not a malfunction and does not affect 
the recorded picture.

Extremely high precision technology is 
employed to produce the Viewfinder screen 
featuring a total of approximately 67,500 
pixels. The result is more than 99.99% 
effective pixels with a mere 0.01% of the 
pixels inactive or always lit. However, this is 
not a malfunction and does not affect the 
recorded picture.

≥Be sure to keep the Lens Hood attached to the 

Movie Camera so as to shut out unnecessary 
light.

• Is the power source connected correctly? (

)

• When the Recording Pause Mode continues 

for more than 6 minutes, the power is turned off 
automatically for tape protection and power 
conservation. (If the AC Adaptor is used, the 
power is turned off only when the tape is 
inserted in Tape Recording Mode.) When the 
tape is inserted in Tape Recording Mode and if 
the Recording Pause Mode continues for more 
than 6 minutes, the power is turned off 
automatically. 
To resume recording from this condition, turn 
off, then turn on the power again.

• Is the Battery low? Charge the Battery or 

attach a fully charged Battery. (

)

• Has condensation occurred? Wait until the 

Condensation Indication disappears. (

)

Battery
1: Battery runs down quickly.
• Is the Battery fully charged? Charge it with the 

AC Adaptor. (

)

• Are you using the Battery in an extremely cold 

place? In cold places, the operating time of the 
Battery becomes shorter. (

)

• Has the Battery worn out? If the operating time 

is still too short even after the Battery is fully 
charged, the Battery has worn out.

2: The Battery cannot be charged.
• If the DC Input Lead is connected to the AC 

Adaptor, charging cannot be performed. 
Disconnect the DC Input Lead.

• Is the accidental erasure prevention slider on 

the Cassette open? If it is open (set to [SAVE]), 
recording cannot be performed. (

)

• Is the tape wound to the end? Insert a new 

Cassette. (

)

• Is the Movie Camera power turned on? (

)

• Has condensation occurred? Wait until the 

Condensation Indication disappears. (

)

33EGE-ENG.book  43 ページ  ２００４年２月９日　月曜日　午前９時５５分