Panasonic nv-sj50am User Manual

14

Before requesting service, check the following 
points again.

VCR (Line Recording) will not operate.
[Mains lead not connected.]
• Reconnect mains lead to mains outlet.

[Safety devices operating.]
• Disconnect mains lead and wait for 1 minute. 

Reconnect mains supply and check functions.

[An unknown language appears on the screen.]
• Select the desired language. See page 5.

Picture noisy or not in colour.
Horizontal bars or lines run down the screen.
[TV not tuned to VCR (Line Recording).]
• Check TV tuning. See page 4.

[Video heads clogged or worn.]
• Condensation may have formed, or a faulty 

tape has been used. See page 3.
Do not operate VCR (Line Recording) for 
1 hour, then insert a new tape (original may be 
faulty) and play back for a few minutes. If fault 
does not clear, consult your dealer for further 
advice.

[Tape defective due to surface damage or wear.]
• Check another tape to see if noise-free and 

replace defective tape.

VCR (Line Recording) rewinds automatically 
during playback.
[Tape end detector works during playback due to 
damaged tape.]
• Replace defective tape.

Remote control does not operate correctly.
[Remote control transmitter beam not reaching 
VCR (Line Recording).]
• Ensure that remote control is pointed at VCR 

(Line Recording) and transmitter beam is not 
obstructed.

[Distance is too far.]
• Use remote control within 7 m of VCR (Line 

Recording). If this range is not possible, 
replace batteries.

[Batteries exhausted.]
• Replace batteries with UM3 or R6 type 

available from your dealer. Note precautions for 
replacement on page 2.

[Batteries incorrectly fitted with reversed.]
• Fit batteries correctly as shown on page 2.

RR5-M_AMfm.book  14 ページ  ２００２年６月６日 木曜日 午後６時２４分