Panasonic PT-50LC13 User Manual

Requires two AA batteries (supplied).

1.  Turn the Transmitter face down. 

Remove top cover by pressing 
down on marking and sliding 
cover off in the direction indicated.

2.  Install the batteries as shown in 

the battery compartment.

 

(Polarity + or - must match the 
markings in the compartment).

3.  Replace the cover and slide 

in reverse until the lock 
snaps.

Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote 
control.
Observe the following precautions:

1.  Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2.  Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
3.  Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
4.  Battery replacement is necessary when the remote control acts sporadically or stops operating the projection 

display set.

Two AA size

1. Remote 

Control 

(EUR7603ZB0)

2. Batteries 

2 

“AA”

3.  RGB Cable  (2 m)  (LSJA0239-1 or LSJA0443)
4.  DVI Cable  (2 m)  (K1HA24DA0003)

(1)  For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life.
(2)  Whenever you remove the batteries, you may need to reset the remote control infrared codes. We 

rec om mend that you record the code on page 70, prior to setting up the remote.

CAUTION