Panasonic PT-D9610U User Manual

15

Always be sure to follow the procedure given below to turn the projector power on and off.

〈Turning the power on 〉

〈 Turning the power off 〉

• The projector will continue to draw approximately 13 W of power when it is in standby mode, even

after the cooling fan has stopped.

•The lamp cooling fan will continue to operate for approximately five minutes after the power is turned off.

At the same time, the self-diagnosis display “FC” will blink.

• When projecting a picture for the first time after setting up the projector, first press the LENS button on 

the remote control unit or the projector operating panel, and then use the control level buttons (+ and -) 
to adjust the basic focus.

• Turning on the power at an ambient temperature of about 0 °C may require a warm-up time of

approximately five minutes to start projecting a picture.

Codes such as “C1, C2 or C3” will appear in the self-diagnosis display during the warm-up.
After the warm-up, the self-diagnosis display will turn off and the projector will project a picture.

• If the ambient temperature is too low and the warm-up time exceeds five minutes, the power will

automatically be turned off as an abnormal condition. In this case, increase the ambient temperature to 

0 °C or higher and then perform the operations “Main power ON 

→ Standby ON” again.

Main power ON

1

Press the [   ] side of the MAIN POWER switch at 
the front of the projector.
 (The projector will change to standby mode.)

Wait about 3 seconds

 Standby ON

2

Press the POWER button on the remote control
 unit or on the projector operating panel.

Picture projected

3

A picture will then be projected.

After about 20 seconds

Standby OFF

1

Press the POWER button on the remote control
 unit or on the projector operating panel.

Main power OFF

2

Press the [〇] side of the MAIN POWER switch at 
the front of the projector.
 (The power will then turn off.)

 Wait about 5 minutes

While projecting a picture  

(The power indicator will become red)

(The power indicator is green)

(The power indicator will become red from 
 green after the cooling fan has stopped)

(The power indicator will become green)