Panasonic PT-AE3000E User Manual

Do not short-circuit, heat or disassemble the 
batteries or place them into water or fire.
 

Failure to observe this may cause the batteries to 
overheat, leak, explode or catch fire, and burns or 
other injury may result.

When inserting the batteries, make sure the 
polarities (+ and -) are correct.
 

If the batteries are inserted incorrectly, they may 
explode or leak, and fire, injury or contamination of 
the battery compartment and surrounding area may 
result.

Use only the specified batteries.
 

If incorrect or different kinds of batteries are used, 
they may explode or leak, and fire, injury or 
contamination of the battery compartment and 
surrounding area may result.

Do not mix old and new batteries.
 

If the batteries are inserted incorrectly, they may 
explode or leak, and fire, injury or contamination of 
the battery compartment and surrounding area may 
result.

Remove the used batteries from the remote control 
promptly.
 

If you leave used batteries in the remote control for 
an extended period of time, it may cause liquid 
leaking, abnormal internal temperature rising or 
explosion.

If not using the projector for an extended period of 
time, disconnect the mains plug from the mains 
socket and remove the batteries from the remote 
control.
 

If dust builds up on the mains plug, the resulting 
humidity may damage the insulation, which could 
result in fire.

 

Keeping or leaving the remote control with batteries 
inside may cause insulation deterioration, electrical 
leakage or explosion which could result in fire.

Do not put your weight on this projector.
 

You could fall or the projector could break, and injury 
may result.

 

Be especially careful not to let young children stand 
or sit on the projector.

Disconnect the mains plug from the mains socket as 
a safety precaution before carrying out any cleaning.
 

Electric shocks can result if this is not done.

If the lamp has broken, ventilate the room 
immediately. Do not touch or bring your face close 
to the broken pieces.
 

Failure to observe this may cause the user to absorb 
the gas which was released when the lamp broke and 
which contains nearly the same amount of mercury 
as fluorescent lamps, and the broken pieces may 
cause injury.

 

If you believe that you have absorbed the gas or that 
the gas has got into your eyes or mouth, seek 
medical advice immediately.

 

Ask your dealer about the replacement of the lamp 
unit and check the inside of the projector.

Ask an Authorised Service Centre to clean inside the 
projector at least once a year.
 

If dust is left to build up inside the projector without 
being cleaned out, it can result in fire or problems 
with operation.

 

It is a good idea to clean the inside of the projector 
before the season for humid weather arrives. Ask 
your nearest Authorised Service Centre to clean the 
projector when required. Please discuss with the 
Authorised Service Centre regarding cleaning costs.

Do not subject the projector to excessive vibration 
or shocks.
 

The projector lens needs to be handled with care.

 

Cover the lens with the lens cover when transporting 
the projector.

When transporting the projector, hold the body at 
the bottom securely.
 

Do not hold the adjuster legs or the top cover to move 
the projector, as this may damage the projector.