Panasonic PT-AX100U User Manual

Page of 52
E
NGLISH
 - 19
Basic Operation
Switching the projector on/off
Ensure all the input devices are connected and turned off before connecting the Power cord.
Connecting
1. Make sure the shape 
of the power cord plug 
and the AC IN
connector on the back 
of the projector match, 
then push the plug all the way in.
2. Connect the Power cord to a wall socket.
Disconnecting
1. Make sure the MAIN POWER is switched off 
and unplug the Power cord from the wall 
socket.
2. Hold the plug and unplug the Power cord
from the AC IN connector on the back of the 
projector.
Power cord
NOTE:
  Do not use any other Power cord than the one supplied with the projector.
  Do not force the connector as this may damage the projector and/or the power cord.
  Dirt or dust build-up around plugs may cause fire or electrical hazards.
  Switch off the power to the projector when not in use.
POWER indicator
Indicator status
Status
No illumination or flashing
The MAIN POWER is switched off.
RED
Lit
The MAIN POWER is switched on and the projector is standby.
GREEN
Flashing
The POWER is switched on and the projector is getting ready to project.
Lit
The projector is ready to project.
ORANGE
Lit
The POWER is switched off and the projector is cooling the lamp.
Flashing
The POWER is switched on again when cooling the lamp and recovering 
to projection mode. Recovery may take a while.
NOTE:
  While the projector is cooling the lamp, do not switch the MAIN POWER off or unplug the Power cord.
POWER indicator