Panasonic PT-AX100U User Manual

If a problem should occur with the projector, the TEMP and/or LAMP indicators will alert you. Respond to the alert 
as follows.

1. Confirm the POWER indicator status and turn off the projector in the proper way.

2. Find out the cause of the problem.

3. Follow the instructions for each indication below and solve the problem.

4. Turn on the projector in the correct way and confirm the indicator is not indicating a problem any longer.

J TEMP indicator

J LAMP indicator

NOTE:
  If no problem is found or the problem remains, do not turn on the projector. Instead contact an Authorized 

Service Center.

  Illuminating RED and still projecting
  Flashing RED and POWER is turned off

The temperature inside and/or outside the projector is abnormally high.

The ventilation ports are 
covered.

The room temperature is too 
high.

The Air filter is excessively 
dirty and the ventilation is 
poor.

Remove the object(s) from 
the ventilation ports or clear 
around the projector.

Reinstall the projector at a 
temperature controlled place.
See “Setting up” on page 14.

Clean or replace the Air filter
in the proper way. See 
“Cleaning the Air filter” on 
page 37.

  Illuminating RED

  Flashing RED

LAMP RUNTIME has reached 1 800 hours 
(with LAMP POWER set to NORMAL).

LAMP circuit failure or abnormal function.

Lamp unit will run out soon and needs to be 
replaced.

The projector is switched off incorrectly.

Replace the Lamp unit. See “Before 
replacing the Lamp unit” on page 38.

  Let the LAMP cool down and turn on the 

projector.

  If the POWER does not turn on, contact an 

Authorized Service Center.