Panasonic SC-HT441W User Manual

One Panasonic Way Secaucus,
New Jersey 07094
http://www.panasonic.com

Ave. 65 de Infantería, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985

C 2006 Matsushita Electric Industrial Co., Ltd.

RQT8779-P

Printed in Malaysia

F0606KN0

p

Please check and identify the supplied accessories. Use numbers indicated in parentheses when asking for replacement parts.
(Product numbers correct as of June 2006. These may be subject to change.)
To order accessories, refer to “Accessory Purchases” on page 38.

∏ 1 Remote control

(N2QAYZ000001)

∏ 2 Remote control batteries

∏ 1 Video cable

(K2KA2BA00001)

∏ 1 AM loop antenna 

(N1DAAAA00002)

∏ 1 FM indoor antenna 

(RSA0007-L)

∏ 2 AC power supply cords

(K2CB2CB00018)

∏ 2 Sheets of speaker cable 

4

4

2

2

6

6

5

3

5

3

1

1

SURROUND

Rch

Rch

SURROUND

Rch

Rch

FRONT

WOOFER

SUB

Lch

Lch

Lch

CENTER

Lch

SURROUND

SURROUND

FRONT

SUB

WOOFER

FRONT

FRONT

CENTER

This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures:
≥ Reorient or relocate the receiving antenna.
≥ Increase the separation between the equipment and receiver.
≥ Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected.

≥ Consult the dealer or an experienced radio/TV technician for help.

FCC caution: To maintain compliance with FCC regulations, shielded 
interface cables must be used with this equipment. Operation with 
non-approved equipment or unshielded cables may result in 
interference to radio and TV reception. Any changes or modifications 
not approved by the party responsible for compliance could void the 
user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including 
interference that may cause undesired operation.

Responsible Party:
Panasonic Corporation of North America
One Panasonic Way
Secaucus, NJ 07094
Telephone No.: 1-800-211-7262

To satisfy FCC RF exposure requirements for mobile transmitting 
devices, a separation distance of 20 cm or more should be maintained 
between the antenna of this device and persons during device 
operation. To ensure compliance, operations at closer than this distance 
is not recommended. The antenna used for this transmitter must not be 
co-located in conjunction with any other antenna or transmitter.

This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions: 
(1) This device may not cause harmful interference,
(2) This device must accept any interference received, including 
interference that may cause undesired operation.

This symbol is only valid in the European Union.
If you wish to discard this product, please 
contact your local authorities or dealer and ask 
for the correct method of disposal.

(Inside of product)

HT441WEn.book  Page 40  Friday, June 9, 2006  5:43 PM