Panasonic sa-xr707 User Manual

RQT8979

The only receivers you should connect to these speakers are

those whose rated output does not exceed the above figures.

Using a receiver with higher ratings than listed above can cause

abnormal sounds to occur because of excessive input, damage to the

receiver or speakers, and fire. If equipment is damaged in any way or

unexpected trouble occurs during playback, unplug the system from its

outlet and call a servicenter for assistance.

These units incorporate protection circuitry to protect them from

damage caused by excessive input or abnormal signals; when

excess input is detected, input is automatically interrupted.

1.Reduce the volume of the receiver.

2.Check the sound source and connections for any problems.

If there is no problem, the protection circuitry will reset in

a few minutes.

Take care not to increase the receiver’s volume too high.

This speaker is provided with a protection circuit. If trouble

develops inside the speaker because the speaker is being used

in an abnormally hot location or because excessively high input

signals are supplied, the protection circuit may be triggered,

shutting down the output.

It could take approximately an hour for the protection circuitry to

reset.

1. Reduce the volume level from the receiver.

2. Press [POWER] to turn the unit off.
3. Check the temperature and connections for problems.
4. Remove the cause of any problems discovered. 

Press [POWER] to turn the unit on.

Should the unit still not function properly…
Pull out the plug and consult your dealer.

You can damage your speakers and shorten their life span
if you keep the volume high over extended periods.
Reduce the volume in the following cases to avoid damage:
• When playing distorted sound.
• When the speakers are receiving howling from a microphone

or record player, noise from FM broadcasts, or continuous
signals from an oscillator, test disc, or electronic instrument.

• When adjusting the sound quality.
• When turning the receiver on or off.

When used with a CRT TV set
• Depending on how the installation is configured, irregular

coloring may occur. If this occurs, turn the television off for
about 30 minutes. The television’s demagnetizing function
should correct the problem. If it persists, move the speakers
further away from the television.

This speaker system is not magnetically shielded.
Do not place it near a PC or other device that is affected by
magnetic fields.
Keep magnetized items away.
Magnetized cards, bank cards, commuter passes, etc., can be
damaged if placed too close to the speaker magnets. Clocks
may also be affected.
Avoid locations such as described below:
• In direct sunlight
• Near heating appliances or other sources of heat
• Where the humidity is high

Impedance

6 

Ω

Input power 

100 W (RATED)